B&B Electronics 714FX6-SC_ST - Manual - Manual (Page 140)

(Revised 2010-2-24) Page 140 of 154
CLI Commands, Continued…
Show or Set CIP Configuration
Command Name Cip
Description Show or set CIP configuration. If no parameters are specified, this command will show
the CIP configuration (same as -show parameter).
Syntax -Cip [-e[nable] | -d[isable] | -show]
Parameters -Cip -show
Show CIP configuration.
-Cip [-e[nable] | -d[isable]]
Set the CIP status to e(nabled) or d(isabled).
Examples N-TRON/Admin> cip -show
CIP Configuration:
------------------
Status: Enabled
EthIp Interval: 10 ms
Cache Interval: 2000 ms
Identity Information:
---------------------
Product Name: N-TRON 714FX6
Vendor: 1006 (N-TRON)
Device Type: 0x0C (Communications Adapter)
Major Revision: 1
Minor Revision: 2
Serial Number: 0xAFFBF8F0
Connection Information:
-----------------------
Multicast Connections: 0
Unicast Connections: 0
N-TRON/Admin> cip -disable
Changing CIP configuration...
CIP Configuration:
------------------
Status: Disabled
EthIp Interval: 10 ms
Cache Interval: 2000 ms
Identity Information:
---------------------
Product Name: N-TRON 714FX6
Vendor: 1006 (N-TRON)
Device Type: 0x0C (Communications Adapter)
Major Revision: 1
Minor Revision: 2
Serial Number: 0xAFFBF8F0
Connection Information:
-----------------------
Multicast Connections: 0
Unicast Connections: 0
N-TRON/Admin>
NOTES