B&B Electronics 714FX6-SC_ST - Manual - Manual (Page 127)

(Revised 2010-2-24) Page 127 of 154
CLI Commands
“?” (Help)
Command Name “?”
Description Show a list of all commands or get help on a specific command.
Without cmd, this command will list all the available commands.
If cmd is specified and if it matches a specific command, the usage of the command will
be displayed; otherwise, if cmd matches the prefix of a command, the name of the
command will be listed.
If ? is preceded by another ?, the usage and description of this command will be
displayed.
Syntax ? [cmd]
Parameters cmd
The command for which to get help.
Examples N-TRON/Admin> ?
N-TRON/Admin> ?
Command Description
------- -----------
? Show a list of all commands or get help on a
specific command.
Logout Log out of console interface.
Arl Show, Add or Delete Arl Entries.
CfgDev Perform configuration device operations.
Config Save or reset configuration settings.
Cip Show or set CIP configuration.
Idle Show or clear idle task statistics.
Igmp Show or set IGMP configuration.
Mirror Show or set the Mirror configuration.
NRing Show or set N-Ring configuration.
NView Show or set N-View configuration.
Ping Ping a host.
Port Show or set Port configuration.
Reset Reset switch.
Shell Start a file command shell.
Snmp Show or set SNMP configuration.
SysErr Show or clear the last system error.
SysInfo Show system information.
SysIp Set system ip configuration mode, IP address,
subnet mask, and gateway.
System Show or set System configuration.
Debug Set/Get debug trace level for a given module.
Use "cmd ?" to get help about a specific command.
N-TRON/Admin>
N-TRON/Admin> abcd ?
Unknown Command: "abcd"
Type "?" for a list of available commands.
N-TRON/Admin> logout ?
Logout
Log out of console interface.
SYNTAX:
Logout
N-TRON/Admin> ? pi