Rainbow Electronics MAX1083 - Manual (Page 4)

MAX1082/MAX1083
300ksps/400ksps, Single-Supply, 4-Channel,
Serial 10-Bit ADCs with Internal Reference
4 _______________________________________________________________________________________
V DD1 =
V DD2 =
5.5V
V
DD1
= V
DD2
= 5V ±10%, midscale input
CONDITIONS
mA
2.5 4.0
IV DD1
+ IV DD2
Supply Current
V 4.5 5.5
V DD1,
V DD2
Positive Supply Voltage
(Note 9)
1.3 2.0
0.9 1.5
µA 2.0 10
mV ±0.5 ±2.0 PSR Power-Supply Rejection
UNITS MIN TYP MAX SYMBOL PARAMETER
Normal operating mode (Note 10)
Reduced-power mode (Note 11)
Fast power-down mode (Note 11)
Full power-down mode (Note 11)
ELECTRICAL CHARACTERISTICS—MAX1082 (continued)
(V DD1 = V DD2 = +4.5V to +5.5V, COM = GND, f OSC = 6.4MHz, 50% duty cycle, 16 clocks/conversion cycle (400ksps), external +2.5V
at REF, REFADJ = V DD1 , T A = T MIN to T MAX , unless otherwise noted. Typical values are at T A = +25°C.)
ELECTRICAL CHARACTERISTICS—MAX1083
(V
DD1
= V
DD2
= +2.7V to +3.6V, COM = GND, f
OSC
= 4.8MHz, 50% duty cycle, 16 clocks/conversion cycle (300ksps), external
+2.5V at REF, REFADJ = V DD1 , T A = T MIN to T MAX , unless otherwise noted. Typical values are at T A = +25°C.)
MAX1083A
SINAD > 58dB
-3dB point
f = 150kHz, V IN = 2.5Vp-p
f IN1 = 73kHz, f IN2 =77kHz
MAX1083B
No missing codes over temperature
Up to the 5th harmonic
CONDITIONS
kHz 250 Full-Linear Bandwidth
MHz 3 Full-Power Bandwidth
dB -78
Channel-to-Channel Crosstalk
(Note 4)
dB 76 IMD Intermodulation Distortion
dB 70 SFDR Spurious-Free Dynamic Range
dB -70 THD Total Harmonic Distortion
LSB
±0.5
INL Relative Accuracy (Note 2)
bits 10 Resolution
dB 60 SINAD
Signal-to-Noise plus Distortion
Ratio
LSB ±0.2
Channel-to-Channel Offset-Error
Matching
ppm/°C ±1.6
Gain-Error Temperature
Coefficient
±1.0
LSB ±1.0 DNL Differential Nonlinearity
LSB ±3.0 Offset Error
LSB ±3.0 Gain Error (Note 3)
UNITS MIN TYP MAX SYMBOL PARAMETER
POWER SUPPLY
DC ACCURACY (Note 1)
DYNAMIC SPECIFICATIONS (75kHz sine wave input, 2.5Vp-p, 300 ksps, 4.8 MHz clock, bipolar input mode)