Rainbow Electronics MAX1207 - Manual (Page 3)

MAX1207
65Msps, 12-Bit ADC
_______________________________________________________________________________________ 3
ELECTRICAL CHARACTERISTICS (continued)
(V DD = 3.3V, OV DD = 2.0V, GND = 0, REFIN = REFOUT (internal reference), C REFOUT = 0.1µF, C L ≈ 5pF at digital outputs, V IN =
-0.5dBFS, CLKTYP = high, DCE = high, PD = low, G/T = low, f CLK = 65MHz (50% duty cycle), C REFP = C REFN = 0.1µF to GND, 1µF
in parallel with 10µF between REFP and REFN, C COM = 0.1µF in parallel with 2.2µF to GND, T A = -40°C to +85°C, unless otherwise
noted. Typical values are at T A = +25°C.) (Note 1)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
f IN = 3MHz at -0.5dBFS -93.6
Second Harmonic HD2
f IN = 32.5MHz at -0.5dBFS (Note 3) -89.4 -82.0
dBc
f IN = 3MHz at -0.5dBFS -96.8
Third Harmonic HD3
f IN = 32.5MHz at -0.5dBFS (Note 3) -92.7 -84.3
dBc
Third-Order Intermodulation IM3
f IN1 = 69MHz at -7dBFS,
f
IN2
= 71MHz at -7dBFS
-90 dBc
Two-Tone Spurious-Free
Dynamic Range
SFDR TT
f IN1 = 69MHz at -7dBFS,
f IN2 = 71MHz at -7dBFS
89 dBc
Aperture Delay t AD Figure 14 0.9 ns
Aperture Jitter t AJ Figure 14 <0.2 ps RMS
Output Noise n
OUT
INP = INN = COM 0.5 LSB
RMS
Overdrive Recovery Time ±10% beyond full scale 1
Clock
cycles
INTERNAL REFERENCE (REFIN = REFOUT; V REFP , V REFN , and V COM are generated internally)
REFOUT Output Voltage V REFOUT 1.988 2.048 2.080 V
COM Output Voltage V COM V DD / 2 1.65 V
Differential Reference
Output Voltage
V REF V REF = V REFP - V REFN 1.024 V
REFOUT Load Regulation 35 mV/mA
REFOUT Temperature Coefficient TC REF +100 ppm/°C
Short to V DD 0.24
REFOUT Short-Circuit Current
Short to GND 2.1
mA
B U F F ER ED EXT ER N A L R EF ER EN C E ( RE FIN d r i ven exter nal l y, V R E F IN = 2.048V , V R E F P , V R E F N , and V C OM ar e g ener ated i nter nal l y)
REFIN Input Voltage V REFIN 2.048 V
REFP Output Voltage V REFP (V DD / 2) + (V REFIN / 4) 2.162 V
REFN Output Voltage V REFN (V DD / 2) - (V REFIN / 4) 1.138 V
COM Output Voltage V
COM
V
DD
/ 2 1.60 1.65 1.70 V
Differential Reference
Output Voltage
V
REF
V
REF
= V
REFP
- V
REFN
0.970 1.024 1.070 V
Differential Reference
Temperature Coefficient
+12.5 ppm/°C
Source 0.4
Maximum REFP Current I REFP
Sink 1.4
mA
Source 1.0
Maximum REFN Current I REFN
Sink 1.0
mA
Source 1.0
Maximum COM Current I
COM
Sink 0.4
mA
REFIN Input Resistance >50 MΩ