1 fcc labelling requirement, 2 national rf approvals, 1 r&tte notification requirement – Rainbow Electronics DAB-WLS-C21 (BlueTooth) User Manual
Page 26
www.EZURiO.com
DSH_BTM402_0v9 BISM2 PA Data Sheet.DOC
© 2007 EZURiO Ltd
26
module is used in a portable device, additional SAR testing must be performed on the complete
product.
12.3.1.1
FCC Labelling requirement
If the FCC ID is not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:
PI408B” or “Contains FCC ID: PI408B.” Any similar wording that expresses the same meaning may be
used.
12.3.2 National RF approvals
A list of the countries where the Module is approved will be provided by EZURiO as required. As a
minimum the product is listed in Europe, Scandinavia, Canada and USA. EZURiO assumes no liability
for customer failure to comply with national RF approval.
12.3.2.1
R&TTE Notification Requirement
The 2.4GHz band has some restrictions within the EU when the transmit power level is greater than
10mW (R&TTE Class 2). Because of this, it is designated within R&TTE as a non-harmonised band.
Such products must be notified to the appropriate Notified Body within each country where it is
placed on the market. EZURiO has notified the WISM module, but manufacturers incorporating it
within their products and intending to sell these within Europe have a responsibility to notify the
appropriate nominated body before commercial introduction. A list of nominated bodies is available
at:
Further details on the notification procedure are given in EZURiO’s Application Note AN016 -
Notification Requirements for Wireless Products.