Rainbow Electronics DAB-WLS-C21 (BlueTooth) - Manual (Page 25)

www.EZURiO.com
DSH_BTM402_0v9 BISM2 PA Data Sheet.DOC © 2007 EZURiO Ltd 25
Insulator Material PA , beige natural
Stacking height 3.0 mm ; 3.5 mm ; 4.0 mm ; 5.0 mm
Insertion force 21.8N
Withdrawal force 1st 10N
Withdrawal force 50th 10N
Maximum connection cycles 50
12. Qualification
12.1 Qualification Process
ion:
ons
The following safety precautions must be observed during all phases of the operation, usage, service
or repair of any application incorporating this Module. Manufacturers of the RF equipment are advised
to convey the following safety information to users and operating personnel and to incorporate these
guidelines into all manuals supplied with the product. Failure to comply with these precautions
violates safety standards of design, manufacture and intended use of the product. EZURiO assumes
no liability for customer failure to comply with these precautions.
12.2 Safety Informat
If the Bluetooth module is used in equipment that might be taken and operated on a commercial
flight, the following safety instructions, or similar warning should be added to the user manual.
“Switch off the Wireless device before boarding an aircraft. Make sure it cannot be switched on
inadvertently. The operation of wireless appliances in an aircraft is forbidden by many airlines to
prevent interference with communications systems.”
12.3
Certificati
12.3.1 Bluetooth Qualification
This device has been tested according to the Bluetooth Qualification program and approved as an
END product, with Bluetooth approval number BOxxx. END product approval means that integrators
do not need to perform any further Bluetooth approvals unless additional profiles are added within
their specific product. To meet the requirements of the Bluetooth SIG, this approval number must be
marked on the final equipment or referenced in the accompanying documentation.
The use of the Bluetooth logo on a product or any associated material is controlled by the Bluetooth
Brand Book. Usage is freely allowed for devices incorporating this END product module, so long as
the manufacturer is a member of the Bluetooth SIG. Membership of the Bluetooth SIG is free and
application can be made at www.bluetooth.org.and Industry Canada Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
To inherit the modular approval, the antennas for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
Co-location with other radio transmitting devices operating concurrently in the same band will require
additional testing and certification.
Designers should note the distinction that the FCC makes regarding portable and mobile devices.
Mobile devices are defined as products that are not used closer than 20cm to the human body,
whereas portable devices can be used closer that 20cm to the body. In the case where the WISM