Eeprom read/write access, Eeprom address register – eear, Eeprom data register – eedr – Rainbow Electronics AT90S1200 User Manual
Page 25: Eeprom control register – eecr
25
AT90S1200
0838H–AVR–03/02
EEPROM Read/Write
Access
The EEPROM access registers are accessible in the I/O space.
The write access time is in the range of 2.5 - 4 ms, depending on the V
CC
voltages. A
self-timing function, however, lets the user software detect when the next byte can be
written. If the user code contains code that writes the EEPROM, some precaution must
be taken. In heavily filtered power supplies, V
CC
is likely to rise or fall slowly on Power-
up/down. This causes the device for some period of time to run at a voltage lower than
specified as minimum for the clock frequency used. CPU operation under these condi-
tions is likely cause the program counter to perform unintentional jumps and eventually
execute the EEPROM write code. To secure EEPROM integrity, the user is advised to
use an external under-voltage reset circuit in this case.
In order to prevent unintentional EEPROM writes, a specific write procedure must be fol-
lowed. Refer to “EEPROM Control Register – EECR” on page 25 for details on this.
When the EEPROM is read or written, the CPU is halted for two clock cycles before the
next instruction is executed.
EEPROM Address Register –
EEAR
• Bit 7, 6 – Res: Reserved Bits
These bits are reserved bits in the AT90S1200 and will always read as zero.
• Bits 5..0 – EEAR5..0: EEPROM Address
The EEPROM Address Register (EEAR5..0) specifies the EEPROM address in the 64-
byte EEPROM space. The EEPROM data bytes are addressed linearly between 0 and
63.
EEPROM Data Register –
EEDR
• Bits 7..0 – EEDR7..0: EEPROM Data
For the EEPROM write operation, the EEDR register contains the data to be written to
the EEPROM in the address given by the EEAR register. For the EEPROM read opera-
tion, the EEDR contains the data read out from the EEPROM at the address given by
EEAR.
EEPROM Control Register –
EECR
• Bits 7..2 – Res: Reserved Bits
These bits are reserved bits in the AT90S1200 and will always be read as zero.
Bit
7
6
5
4
3
2
1
0
$1E
–
–
EEAR5
EEAR4
EEAR3
EEAR2
EEAR1
EEAR0
EEAR
Read/Write
R
R
R/W
R/W
R/W
R/W
R/W
R/W
Initial Value
0
0
0
0
0
0
0
0
Bit
7
6
5
4
3
2
1
0
$1D
MSB
LSB
EEDR
Read/Write
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Initial Value
0
0
0
0
0
0
0
0
Bit
7
6
5
4
3
2
1
0
$1C
–
–
–
–
–
–
EEWE
EERE
EECR
Read/Write
R
R
R
R
R
R
R/W
R/W
Initial Value
0
0
0
0
0
0
0
0