Rainbow Electronics UC864 - Manual (Page 16)

UC864-E/G Product Description
80281ST10034a Rev. 1 - 08/08/2008
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 16 of 36
2.10 WCDMA/GSM Power consumption
The typical current consumption of the
Telit UC864-E/G is:
Power off current (typical) < 26
µ
A;
Stand–by current (WCDMA Idle) < 23.2mA (<5.3mA using command AT+CFUN=5)
Stand–by current (GSM Idle) < 15.0mA (<3.6mA using command AT+CFUN=5)
Operating current in WCDMA voice channel < 690 mA @ worst network conditions
Operating current in GSM voice channel < 317 mA @ worst network conditions
Operating current in WCDMA data channel < 680 mA @ worst network conditions
Operating current in HSDPA channel < 730 mA @ worst network conditions
Operating current in GPRS Class 12 < 790 mA @ worst network conditions
Operating current in EGPRS Class 12 < 560 mA @ worst network conditions
2.11 Embodied Battery charger
The battery charger is suited for 3.7V Li-Ion rechargeable battery (suggested capacity 500-1000mAH).
The Charger needs only a CURRENT LIMITED power source input and charges the battery directly
through VBATT connector pins.
Battery charger input pin CHARGE
Battery pins VBATT, GND
Battery charger input voltage min 5.0 V
Battery charger input voltage typ 5.5 V
Battery charger input voltage max 7.0 V
Battery charger input current max 400mA
Battery type Li-Ion rechargeable
NOTE: If embodied battery charger is used, then a LOW ESR capacitor of at least 100
µ F must be
mounted in parallel to VBATT pin.
NOTE: when power is supplied to the CHARGE pin, a battery must always be connected to the
VBATT pin of the UC864-E/G.