TC Electronic P2 - Manual (Page 16)

28 29
EQ PAGE
Introduction
This digital EQ features a three-band
parametric EQ with high- and low-pass filters
switchable between Notch, Parametric,
Shelving and Cut filters. The needle sharp
notch filter has a range down to 0.01 octave
and the shelving filters has a variable slope,
ranging from gentle 3 dB/oct over 6 and 9 to
12dB/oct. Cut filters are switchable between
12dB/oct maximum flat amplitude (Butterworth)
or flat group delay (Bessel) types. The
parametric equalizer features a natural and well
defined bandwidth behavior at all gain and
width settings.
Basic operation
• Press keys Lo, Mid and Hi to
activate/deactivate the EQ bands.
• Select Freq, Gain, Type or Lo/Hi to access all
four parameters on individual bands.
• Press Bypass EQ to bypass all three bands.
Type Selector
• Press Type and use faders 1-3 to select filter
types.
For Lo and Hi filters select between filter types:
Parametric, Notch, Shelve and Cut.
For the Mid filter select between filter types:
Parametric and Notch.
Parametric Filter - Broad type
EQ Page
EQ PAGE
Shelving Filter
Notch Filter - Narrow Type
Cut Filter - Bessel type
Cut Filter - Butterworth type
Freq
Press Freq and use Faders 1 to 3 to adjust
frequence for each of the three bands.
Range - Lo band : 20Hz to 20kHz
Range - Mid band : 20Hz to 20kHz
Range - Hi band : 20Hz to 40kHz
Gain
Press Gain and use Faders 1 - 3 to adjust gain
for each of the three EQ bands.
Range for the Parametric, Shelve and Cut type:
Lo Gain
: -12dB to +12dB
Mid Gain : -12dB to +12dB
Hi Gain
: -12dB to +12dB
Range for the Notch filter:
Lo Gain
: -100dB to 0dB
Mid Gain : -100dB to 0dB
Hi Gain
: -100dB to 0dB