RocketFish RF-TVMFM01 - User Manual - Manual (Page 10)

10 Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
RF-TVMFM01V2 TV Wall Mount
STEP 5 - Option 2: Attaching the hardware and mounting the TV to the arm assembly
for TVs with an irregular or inset back
1 Install spacers (E), washers (D), and screws (C) into the top two holes in the back of the TV.
2 Leave a gap between the spacer and the washer and screw.
3 Mount the TV by fitting the top spacers, screws, and washers over the notches in the top of the arm
assembly plate.
4 Install the bottom spacers (E), screws (C), and washers (D) into the bottom holes. If the hole pattern on your
TV is 75mm x 75mm, do not use washers.
5 Make sure that the bracket is level, then tighten all screws carefully until snug.
You’ll need
HEAVY! You will need
assistance with this step.
Phillips screwdriver
Screws Washers
D (4)
C (4)
Screws Spacers
E (4)
Level
Arm assembly (A)
RF-TVMFM01V2_13-0599_MAN_V4_ENG - GIFs.fm Page 10 Friday, June 28, 2013 8:10 AM