RocketFish RF-TVMFM02 - User Manual - Manual (Page 12)

12 Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
RF-TVMFM02V2 TV Wall Mount
Step 6 -Option 1 - Install the wall plate to a wood stud wall
Note: Drywall covering the wall must not exceed 5/8" (16 mm).
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder and mark the center.
2 Align the wall plate template (E) at the height you determined in the previous step and make sure that it is
level. Tape the wall plate template to the wall, then use a pencil to mark the lag bolt hole locations (2).
Remove the wall plate template.
3 Drill pilot holes to a depth of 3" using a 7/32" diameter drill bit.
4 Align the arm assembly (A) with the pilot holes, then place the lag bolt washers (S) over the holes in the arm
assembly (A). Insert the lag bolts (T) through the washers, then tighten the lag bolts with the socket wrench
only until the washers (S) are firm against the arm assembly.
CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (T).
You’ll need
Wall
Home
position
Full
extension
Note: TV shifts 6.99 in. (177.5 mm)
laterally from the home position to
full extension.
9.72 in. (246.9 mm)
6.99 in.
(177.5 mm)
Note: Minimum wood stud size:
common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1.5 x 3.5 in.)
S (2)
Edge-to edge
stud finder
T (2)
Pencil
Drill
7/32" wood
drill bit 1/2" socket
wrench
Level
Tape
Arm
assembly (A) Template (E)
RF-TVMFM02V2_13-0600_MAN_V4_ENG - GIFs.fm Page 12 Tuesday, July 9, 2013 8:02 AM