Cobalt Digital COMPASS 9212-EO 3G_HD_SD-SDI Fiber Transmitter - Manual (Page 28)

3-6 •••• User Controls 9211-OE, 9212-EO User Manual
LED Color Display and Description
Green When lit, this LED indicates that a valid input signal is present.
OK/ERROR
Red When lit red, this LED indicates a valid input signal is not present.
Green
When lit green, this LED indicates that the reclocker is locked to the
input signal.
Red
When lit red, this LED indicates that the reclocker is unable to lock
to the input. This typically indicates that the input data rate is
different from the configured reclocking rate, or that the input is an
unsupported data rate.
LOCK
Off When unlit, this LED indicates that the reclockers is set to Bypass.
AUTO
Yellow
When lit, this LED indicates that the reclocker is configured to lock
to any supported input data rate, using an automatic rate detection
scheme.
MANUAL
Yellow
When lit, this LED indicates that the reclocker is configured to a
fixed data rate or to Bypass. When configured to a fixed data rate,
automatic data rate detection is disabled.
BYPASS
Yellow
When lit, this LED indicates that the reclocker is manually
configured to Bypass. The card output is not reclocked.
OTHER
Yellow This LED is not implemented.
270
Yellow
When lit, this LED indicates that the reclocker is set to a fixed rate
of 270Mbps (SD) or is configured in Auto mode and is locked to a
270Mbps SD signal.
1G5
Yellow
When lit, this LED indicates that the reclocker is set to a fixed rate
of 1.5Gbps (HD), or is configured in Auto mode and is locked to a
1.5Gbps HD signal.
3G
Yellow
When lit, this LED indicates that the reclocker is set to a fixed rate
of 3Gbps (HD), or is configured in Auto mode and is locked to a
3Gbps HD signal.
Green
When lit green, this LED indicates that the Fiber Tx signal is
functioning normal and that no anomalies have been detected.
FIBER TX
OK/ERROR
*
Red
hen lit red, this LED indicates that there is a fault condition with
he Fiber Tx signal.
* This LED only applies to the 9212-EO.