Cobalt Digital COMPASS 9362 HD_SD-SDI Test Signal Generator - Manual (Page 37)

9362-OM (V4.1) 9362 PRODUCT MANUAL 3-11
Operating Instructions
9362 Function Submenu List and Descriptions
(continued)
Note: • When input video is active on output, embedded channel routing is per assignment in program SDI video. Source,
destination, and other controls here only control TSG audio (overwrite using card tone generators or silence).
• Embedded Ch 2 thru Embedded Ch 8, and Embedded Ch 9 thru Embedded Ch 16 have controls identical to the
Source, Gain, Mute, and Phase controls described here for Embedded Ch 1. Therefore, only the Embedded Ch 1
controls are shown here.
• For each channel, its source and destination should be considered and appropriately set. Unused destination channels
should be set to the Silence selection.
• Tone Generator 1 thru 4 as Source Tone Generator 1 thru Tone Generator 4 range in Source drop-down list
enables one of four tone generators (Tone 1 thru Tone 4) to be the source
for the selected destination Embedded Audio Group channel.
(In this example, Tone 1 (tone generator 1) is the source for destination
Embedded Ch 1)
Note: Tone generator frequencies can be independently set for the four
tone generator sources.
Refer to Tone Generator function description on page 3-16 for
more information.
• Silence (Mute) as Source Silence selection in Source drop-down list mutes the selected destination
Embedded Audio Group channel. Use this setting for unused
destination channels.
(In this example, silence (muting) is applied to Embedded Ch 1)
• Gain (dB) Control Adjusts relative gain (in dB) applied to the corresponding destination
Embedded Audio Group channel.
(-80 to +40 dB range in 0.1 dB steps; unity = 0.0 dB)
• Mute Control Allows pushbutton On/Off channel muting while saving all other settings.
• Phase Control Selects between Normal and Invert phase (relative to source original
phase) for the destination Embedded Audio Group channel.
Table 3-2 9362 Function Submenu List — continued