Cobalt Digital COMPASS 9362 HD_SD-SDI Test Signal Generator - Manual (Page 24)

2
Installing a Rear I/O Module
2-4 9362 PRODUCT MANUAL 9362-OM (V4.1)
Install a Rear I/O Module as follows:
1. On the frame, determine the slot in which the 9362 is to be installed.
2. In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.
Figure 2-2 Rear I/O Module Installation
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2