Cobalt Digital COMPASS 9362 HD_SD-SDI Test Signal Generator - Manual (Page 15)

9362-OM (V4.1) 9362 PRODUCT MANUAL 1-11
Introduction
9362 Functional Description
9362 Rear I/O Modules
The 9362 physically interfaces to system video connections at the rear of its
frame using a Rear I/O Module.
All inputs and outputs shown in the 9362 Functional Block Diagram (Figure
1-1) enter and exit the card via the card edge backplane connector. The
Rear I/O Module breaks out the 9362 card edge connections to BNC
connectors that interface with other components and systems in the signal
chain.
These BNC connections are provided by using an optional Rear I/O Module.
The 9362 Rear I/O Modules are shown and described in Chapter 2,
“Installation and Setup”.
Audio and Video Formats Supported by the 9362
The 9362 supports all current SMPTE standard SD and HD video formats.
Table 1-1 lists and provides details regarding the audio and video formats
supported by the 9362.
Table 1-1 Supported Audio and Video Formats
Item Description/Specification
SDI Program Video Input /
Output Raster Structure: Frame Rate:
1080PsF 23.98; 24
1080p 23.98; 24
1080i
(1)
25; 29.97; 30
720p 23.98; 24; 25; 29.97; 30; 50; 59.94;
60
486i
(1)
29.97
575i
(1)
25
Embedded Audio The 9362 supports all four groups (16 channels) of embedded audio at
full 24-bit resolution in both SD (with extended data packets) and HD.
(1) All rates displayed as frame rates; interlaced (“i”) field rates are two times the rate value shown.