Round 4, Indirect/direct, Suspended — 4” round – Peerless Lighting RD4M4 - LED User Manual
Page 2: Rd4m4
2246 5th Street, Berkeley, CA 94710
•
Tel: 510.845.2760
•
Fax: 510.845.2776
•
INTEGRATED NLIGHT MICRO SENSOR
350
350
700
1050
Type:
________________________
Project:
______________________
Suspended — 4” Round
RD4M4
PHOTOMETRICS
WEIGHTS & SUPPORT SPACING
CONFIGURATIONS
Round 4
LED
Indirect/Direct
Suspension spacing equals section length.
Round 4 can be configured with special mitered sections to provide
seamless corner illumination where two luminaires join together.
Reference
or additional details.
Actual performance may differ as a result of end-user environment and application.
2
© 2013 Acuity Brands Lighting, Inc. All Rights Reserved. “Peerless” and “Peerless Bruno” are registered trademarks of Acuity Brands Lighting.
Products in this document may be covered by one or more U.S. Patents and Patents Pending. Specifications subject to change without notice.
1-year limited warranty. Complete warranty terms locat
Indirect/Direct
RD4M4 Round 4 LED
Network Type & Sensor Power Source (choose one)
1*
nLight-Enabled (Network-Ready) with Luminaire-Integrated Power Pack
10’ Cat-5e cable and splitter provided
2
Standalone Operation (No Networking) with Luminaire Integrated Power Pack
No Cat-5e cable provided
3*
nLight-Enabled (Network-Ready) with Remote nLight Power Pack or nPanel
10’ Cat-5e cable and splitter provided
Order required remote nLight Power Pack or nPanel
separately through nLight (Acuity Brands Controls)
Determine the appropriate sensor type, network type and sensor power source for your application. Enter the code in the Options section of the Catalog Number.
EXAMPLE:
PDT1
Sensor Type (choose one)
ADC
nLight model
nES ADCX
Daylight Dimming
Specify 0-10V dimming ballast
No occupancy sensing
PDT
nLight model
nES PDT7 ADCX
Daylight Dimming and/or Occupancy Detection
Specify 0-10v dimming ballast for daylight dimming
Specify fixed-output ballast for occupancy detection only
(daylight dimming disabled)
For more information about the Integrated nLight Micro Sensor, its capabilities and options, do
*nLight-Enabled (network-ready) options include one RJ-45 connector on the luminaire, 10 feet of Cat-5e cable to control the entire luminaire row (depending on
wattage/voltage limitations), and splitter. The Cat-5e cable drop is located in the same section as the sensor. For multiple zones, please contact [email protected].
STANDARD SECTIONS
4’-
1
⁄
4
”
4’-6
1
⁄
4
” O.A.
3” for end cap
2”
8’-6” O.A.
8’-0”
PLAN VIEW
Key:
•
Support or feed location
Sensor
18 LBS
34 LBS
W40/20 LP835
75 lumens per watt
4493 delivered lumens
66% up / 34% down