Daystar KJ09127BK - Manual (Page 6)

10. Once the coil spring is compressed , install it in the Jeep over the
spring spacer.
11.
Now that the coil springs are installed go ahead and install your
lifted front shocks( not supplied.) and raise up the axle and connect
the sway bar end link and track bar to axle mount.
12. With the front suspension back together install the front tires and lower
off the jack stands and place back on the ground.
13. Place the wheel chocks at the front of the front tires and jack up the
rear and place jack stands in front of the rear lift springs and lower
down onto the jack stands, with the floor jack under the axle.
14. Remove the rear tires and disconnect the rear shocks.
15. With the axle supported by the floor jack, carefully remove the upper
and lower spring shackle mounting hardware. Lower the axle carefully
until the shackle can be removed.
16. Lube the bushing and install the 4 shackle bushings and 2 steel sleeves
in the shackles and install the bushing side in the frame side of the
Jeep.