Daystar KJ09127BK - Manual (Page 2)

Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system . In addition to
these instructions , professional knowledge of disassemble/reassembly proce-
dures as well as post instructions checks must be known. Attempts to install this
system without this knowledge and expertise may jeopardize the integrity and/or
operating of the vehicle.
Please read all the instructions before beginning the installation. Check the kit
hardware against the parts list. Be sure you have all the needed parts and under-
stand where they go. If anything is missing , do not proceed with the installa-
tion, call Daystar Products to obtain needed items.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly recom-
mend , because of rollover possibility, that seat belts and shoulder harness be
worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/
heavier tires and wheels are used. Take this into consideration while driving,
Also , speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase
vehicle height over the intended height of the Daystar Product purchased. Mixing
component brands, lifts, and/or combining body lift with suspension lift voids all
warranties. Daystar makes no claims regarding lifting devices and excludes any
and all implied claims. We will not be responsible for any products that are al-
tered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant re-
minder for whoever is operating the vehicle of its unique handling characteristics.
INSTALLING DEALER— Its is your responsibility to install the warning decal
and forward these instructions on to the vehicle owner for review and to be kept
in the vehicle for service life.
After installation occurs, a qualified alignment facility is required to align the
vehicle to factory specs.
Other Jeep Cherokee products .
• KJ01009 1” inch transfer case drop
• KJ03002 Front control arm bushing kit
• KJ02008 Rear spring bushing kit
• KU70083 Upper adjustable control arm kit
• KU70084 Lower adjustable control arm kit
• KJ70028 Front winch bumper w/o skid plate
• KJ70034 Rear bumper
• KJ70035 Rock Rails w/o side plates
More product at www.Daystarproducts.com
Rear Bumper
Lower control arms
Upper control arms