Daystar KU70038BK-2 User Manual
Page 4
1. Thread the S11104 3/4-16 jam nut (
1
) onto the u-rod end (
2
) and
thread that into the S11095 control arm (
3
).
2. Thread on the S10819 3/4 jam nut onto the rod end assembly's
(
5
).
3. Thread the rod end (
5)
into the control arm (
3
).
4. Set the control arm to length.(
6
)
5. With a measuring tape set the arms to stock length if not lifted. If
lift adjust arm length out a .250 per inch of lift. This is not a set
length. You will need a 4 wheel alignment to set the wheels to
factory spec after
installation of control arms.
Control arm assembling steps
1-S11104
2
3
4-S10819
5
6
6.
Raise up the jeep and place floor jacks under the frame. Place
wheel chocks behind the rear wheels.
7.
Remove the wheels and place the jack under the front axel and
support it.
8.
With a 18mm wrench and socket remove the front upper control
(
2
) arm bolts (
1
).
Installation steps