Daystar KU70038BK-2 - Manual (Page 2)

Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system .In addition to these
instructions , professional knowledge of disassemble/reassembly procedures as well
as post instructions checks must be known. Attempts to install this system without
this knowledge and expertise may jeopardize the integrity and/or operating of the
vehicle.
Please read all the instructions before beginning the installation. Check the kit hard-
ware against the parts list. Be sure you have all the needed parts and understand
where they go. If anything is missing , do not proceed with the installation, Call
Daystar Products to obtain needed ite
ms.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly recom-
mend , because of rollover possibility, that seat belts and shoulder harness be worn
at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/heaver
tires and wheels are used. Take this into consideration while driving. Also , speed-
ometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase vehi-
cle height over the intended height of the Daystar Product purchased. Mixing com-
ponent brands, lifts, and/or combining body lift with suspension lift voids all war-
ranties. Daystar makes no claims regarding lifting devices and excludes any and all
implied claims. We will not be responsible for any products that is altered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant re-
minder for whoever is operating the vehicle of its unique handling characteristics.
INSTALLING DEALER— Its is your responsibility to install the warning decal
and forward these instructions on too the vehicle owner for review and to be kept
in the vehicle for service life.
After installation occurs, a qualified alignment facility is required to align the ve-
hicle to factory specs
.
13. With a 5/8 wrench and 5/8 socket wrench and extension
tighten the rear bolts to 75ft lbs.
14. With a 18mm wrench and 18mm socket tighten the front
bolts to 75ft lbs.
15. With the control arms installed lube the joints.
16. You will need to have a wheel alignment done.
17. At that time have the alignment shop use the use the thread
lock on the Jam nuts.
18. Check the bolts and nut after 500 miles and every 5000 miles
or off road use.