Daystar KU70038BK-2 User Manual
Page 3
9. Due to exhaust clearance on the passenger side you will have to
cut the bolt off..
10. One side at a time. Remove the bolts and the control arm.
11. Install the Daystar control arm. Reuse the stock bolts in the
front mounting of the control arm.
12. Install the rear bolt from the frame as show.
Installation steps
Poly Flex joint assembly
1. Using a retaining clip pliers install the C-clip (
1
) into the steel shell (
4
)
then place the washer (
2
) into the shell (
4
).
2. Put a small amount of poly-lube over the poly-flex bushing (
3
) then
install it over the steel washer (
2
)in the steel tub.(
4
)
3. Put a small amount of poly-lube over the steel ball (
5
) and then install it
in the steel tub (
4
) then install the other poly-flex bushing (
6
) over the
steel ball (
5
) .
4. Using the ploy-flex joint tool.( KU70091) Place the assembly (
2
)into
the large tool (
1
)and the place the washer (
3
) and C-clip (
4
)over opened
end off the assembly (
2
).
5. Place the small tool (
5
) over the washer (
3
) and push the 7/16 bolt (
6
)
threw the assembly(
2
) and thread on the 7/16 nut.
6. With a 5/8 wrench and 5/8 ratchet on the bolt and nut tighten them down
so you can install the c-clip (
4
) using a c-clip pliers.
7. Repeat step's on the other threaded rod end.
1- S10617
2- S10135
3-M00492
4– ref
5-S10616
6-M00494
2
1
1
2
3
5
6
4
1
2