Daystar KU70038BK-2 - Manual

TOOLS NEEDED
• Press or vice ( Daystar tool KU70091)
• Retaining clip pliers
• Floor jack
• Jack stand (s) 4
• Wheel chock
• Grease ( poly lube gun KU11005)
• 3/4 drive ratchet
• 10” 3/4 extension
• 5/8 wrench and 5/8 socket
• Measuring tape
• 18mm wrench
• 18mm socket
• Cut off wheel
BILL OF MATERIALS
Part # Description Qty
S11095 Ft Upper Arm 2
S11086 End U-strap 2
S11068 Left hand stud end 2
BU70032 Hardware kit 1
Hardware BOM
M00490 BUSHING 2
M00491 BUSHING 2
S10611 STEEL BALL 2
S10614 C-CLIP,SNAP 4
S10613 WASHER FLAT 4
S10639 7/16 BOLT 4
S10203 7/16 LOCK NUT 4
S10819 3/4 JAM NUT 2
S11104 LT 3/4 JAM NUT 2
P11183 THREAD LOCK 1
Jeep JK Products
• KJ09138 3/4” Front & rear lift
• KJ09137 1 3/4” Front & rear lift
• KU09059 EVS Foam bump-stops
• KU09060 EVS Foam bump-stops
• KU70034 Ft lower control arms
• KU70033 Rear upper control arms
• KU70037 Rear lower control arms
• KU70091 poly flex tool
• KU11005 Poly lube gun
KU70032
2007 to Current Jeep JK control arm kit
www.Daystarproducts.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71 st Avenue
Instruction Sheet P11238
2007 Daystar Products International Inc.
Hells gate, Moab UT