Snap-On DTT - Manual (Page 17)

5d. Press the CHANGE button next to OPERATOR ID to
enter an Operator Identification number if required
(Figure 10).
NOTE: The OPERATOR ID screen can be changed
from Alphabetical (Figure 10) to Numerical
(Figure 11) Mode and vice versa by pressing
the A-Z or 0-9 key respectively.
If the incorrect value is entered, press BS to
clear the last digit entered, or press CLEAR to
delete the entire entry.
The OPERATOR ID screen can be left blank If
the Operator Identification is not required.
An 8 digit long alpha-numeric combination can
be entered in the OPERATOR ID screen.
Press NEXT to accept the entry and return to the
TEST SETUP screen.
15
DTT Digital Torque Tester
ENTER OPERATOR ID:
CLEAR NEXT
Figure 10: Operator ID screen (Alphabetical Mode)
Q W E R T Y U I O P
A S D F G H J K L
0-9 Z X C V B N M BS
TECH
ENTER OPERATOR ID:
CLEAR NEXT
Figure 11: Operator ID screen (Numeric Mode)
5 6 7 8
1 2 3 4
A-Z 9 0 BS
TECH512