Grain Systems Unload Augers PNEG-1555 - Manual (Page 30)

30 PNEG-1555 8" Commercial Vertical Drive Unit - Dual Drive
8. Operation/Maintenance
Operate the Auger
NOTE: The auger capacity can fluctuate greatly under varying conditions. Moisture content, different
commodities, amount of foreign matter and speeds all play a part in the performance of the
auger. Twenty-five percent (25%) moisture may cut capacity by as much as 40% under
some conditions.
1. Make certain there are at least two (2) people in the work area to monitor operations at all times.
2. Visually inspect the auger periodically during operation.
3. When augers are stopped and restarted under full load, it may result in damage to the auger. Using
a larger diameter auger and reducing its load level will be far better than subjecting a smaller
diameter auger to big loads. If an auger is kept from absolute filling, it will make start-up easier and
will convey more efficiently.
Maintain the Auger
1. Use caution when repairing or replacing equipment parts.
2. Make sure ALL decals are legible and tightly attached to the auger. If necessary, replace them
FREE OF CHARGE by contacting your dealer or the manufacturer.
3. Ensure that ALL electric motors, etc., are operating at the proper speed.
4. Maintain proper adjustments on the belt(s).
5. Mount controls for any electric motors at a safe distance from the machine and in a location
accessible in case of an emergency.
6. Make sure ALL electrical wiring is not damaged, and that it meets proper wiring codes.
7. Make sure ALL components are in good working condition before use.
8. Check the auger flight to make sure it is in good working condition.
9. Grease the bearings at least two (2) times each season.
Be alert for any unusual vibrations, noises and the loosening of any fasteners. If
anything unusual is detected, immediately shut down the auger, disconnect and
lock out the power source before servicing.
ALWAYS shut down, lock out, and disconnect the power supply before adjusting,
servicing or cleaning the equipment.