Grain Systems Unload Augers PNEG-1555 - Manual (Page 22)

22 PNEG-1555 8" Commercial Vertical Drive Unit - Dual Drive
4. Installation
P. Loosely bolt the brackets to the head plate using four (4) 5/16'' x 1'' bolts, flat washers, and
serrated flange nuts.
Q. Place and position the 1/4" square x 3" key into the keyway located on the drive shaft.
R. Place the 15" auger pulley onto the drive shaft with the set screw side of the auger pulley facing
away from the head plate. Position the auger pulley so that it is as close to the lock collar as
possible, but not touching it.
S. Once the pulley is appropriately positioned, tighten the set screw with a hex head wrench to
secure it to the drive shaft.
Figure 4T
T. Attach the motor to the motor mount plate on the horizontal drive, using appropriate bolts,
lock washers, and hex nuts.
Motor Bolt Selection
Motor Frame Hex Bolt Size Qty
56
5/16"-18 x 1-1/4" 4 143T
145T
182T
3/8"-16 x 1-1/4" 4
184T
213T
215T
254T
1/2"-13 x 1-3/4" 4
256T