Grain Systems Unload Augers PNEG-1555 - Manual (Page 21)

4. Installation
PNEG-1555 8" Commercial Vertical Drive Unit - Dual Drive 21
K. Slide the motor mount pivot rod through the pivot holes on the motor plate and motor mount plate.
Insert the 3/4'' flat washer between the motor plate and the motor mount plate for the front pivot hole.
L. When the pivot rod begins to extend through the back pivot hole on the motor mount plate,
install the spacers BETWEEN it and the inner face of the motor plate.
Figure 4R
M. Secure the motor mount pivot rod in place with two (2) 3/16" x 2" cotter pins. With the cotter
pins in the pivot rod, bend one tab of the cotter pin back so that it touches the pivot rod, and
bend the other tab of the cotter pin away from the first tab.
N. Loosely install the upper motor mount adjustment washer and nut onto the threaded rod, over
the motor mount plate.
O. Place the left and right hand belt guard brackets up to the head plate. The left hand bracket is
longer than the right hand bracket.
Figure 4S