Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 4)

4
96811 v.10.0
Dear Customer, If you have
any questions concerning the
installation of your Banks Six-
Gun Diesel Tuner, please call
our Technical Service Hotline at
(888) 839-2700 between 7:00
am and 5:00 pm (PT). If you
have any questions relating
to shipping or billing, please
contact our Customer Service
Department at (888) 839-5600.
Thank you.
1.
For ease of installation of your
Banks system, familiarize yourself
with the procedure by reading the
entire manual before starting work.
This manual contains 46 pages of
copy, illustrations and parts listing.
If any pages are missing from this
manual please call Gale Banks
Engineering immediately for a
replacement.
2.
The exploded illustrations provide
only general guidance. Refer to each
step and section diagram in this
manual for proper instruction.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right-side to the
passenger’s side.
4.
Disconnect the ground cable from
the battery before beginning work. If
there are two batteries, disconnect
both.
5.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more
is recommended where possible.
6.
During installation, keep the
work area clean. If foreign debris
is transferred to any Banks system
component, clean it thoroughly before
installing.
7.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides; put the transmission in
park; set the parking brake; and place
blocks behind the rear wheels.
Caution! Do not use floor jacks
to support the vehicle while
working under it. Do not raise
the vehicle onto concrete blocks,
masonry or any other item not
intended specifically for this use.
8.
The Palm Tunsten E2 will need to
be charged for a minimum of
1-2 hours before the Banks software
can be installed. Locate the supplied
Ac-outlet wall charger, also located
in your kit and plug the charging cord
into the Tungsten E2. Please refer
to the Banks PowerPDA Software &
Installation Kit, Owners Manual for
additional instruction.
Warning: The PDA may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDA be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDAs resulting from exposure
conditions.
General Installation Practices