Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 26)

26
96811 v.10.0
Note: If you are not installing the
optional Banks PowerPDA then coil
up and secure cable with the RJ12
(telephone style) connector end.
17.
Remove the fuse box cover,
located in the cabin compartment.
Locate the mini-fuse #22 and remove.
Install the mini-auto blade fuse tap
onto the removed mini fuse as shown
in Figure 35 Re-install the mini fuse
with the attached blade tap into
location #22 as shown in Figure 36.
18.
Locate the RED single terminal
connector on the ‘OBDII Interface
cable’ and connect it to the mini-
fuse blade tap location #22. Replace
the fuse cover and make sure not to
pinch the RED single terminal wire.
Mounting The OttoMind6 Diesel
Tuner
19.
2003-04 model year vehicles
only: Remove the clip shown in
Figure 37 to create adequate room
to mount the OttoMind6 Diesel Tuner
to the driver side inner fender.
20.
2003-04 four-wheel drive
vehicles: The module shown in
Figure 38 will appear only in four-
wheel-drive vehicles. This may need
to be relocated to make room for the
OttoMind6 Diesel Tuner. The mounting
location of this module by the factory
has not been consistent on early
vehicles.
NOTE: Make sure the entire mounting
surface is clean and free of dirt and oil
before mounting the OttoMind6 Diesel
Tuner. Clean and dry as required using
a cloth damped in rubbing alcohol or
similar cleaning solution.
Figure 32
Figure 31
Figure 33