Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 18)

18
96811 v.10.0
15.
For 2005-07 4-wheel drive
equipped vehicles only: Remove
the electronics module near the
driver side battery shown in Figure
13. The retaining tab for the module
can be pried back with a flat blade
screwdriver as shown in the Figure
13.
After the tab is depressed, the module
can easily be pulled away from it’s
mounting bracket.
Note: Be careful not to break the
plastic box, as it will be re-installed
later
16.
Remove the wire harness plastic
retaining clip on the back of the
plastic battery box.
17.
Remove the plastic battery box
[(4x) 13mm socket].
For 2005-07 4-wheel drive
equipped vehicles only: A small
bracket used to mount an electronic
module will also be removed with the
plastic battery tray.
18.
Remove both the driver and
passenger side boost tubes and their
attachment hoses. The passenger
side boost tube is the 3-inch diameter
tube that connects the compressor
discharge to the charge air cooler.
The driver’s side boost tube connects
the charge air cooler to the intake
manifold. Retain the hose clamps
that attach the passenger side boost
tubes to the turbocharger, as these
components will be re-used.
19.
Remove the four Allen head bolts
that attach the stock intake elbow.
The intake elbow is the 90-degree
transition from the driver side boost
tube to the intake manifold.
Figure 12
Figure 13