Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 22)

22
96811 v.10.0
54.
Secure the High Ram with (4x)
1 ⁄ 4 ”-20 Nylon locking nuts. Torque to
9 ft-lbs.
NOTE: Before slipping any boost tubes
and the corresponding hoses, into
position, ensure that all connection
ends are clean and free of any oil
residue and contaminates.
clean compressor outlet and all
connection points with a non-oil
based solvent such as Acetone,
Mineral Spirits, Denatured Alcohol or
Lacquer Thinner. Read and follow the
manufactures operation instruction
for non-oil based solvent cleaner.
55.
Install the driver and passenger
side boost tubes and connection
hoses as shown in Figure 8 The
connection hoses should be slid
firmly against the hose stops
provided on the cAc and High
Ram. Allow a minimum 1 ⁄ 8 ” air gap
between cAc, High Ram and boost
tubes. Note: The a/c line on the
passenger side may need to be bent
to provide clearance for the boost
tube. On 2003 to 2004 vehicles: The
brake line on the driver side may
need to be slightly bent to provide
additional clearance for the boost
tube. On 2005-07 vehicles: One of the
power steering fluid lines may need
to be bent to provide clearance for
the driver side boost tube.
56.
The hose clamps on the High
Ram must be positioned as shown in
Figure 21 to avoid contact with the
hood.
57.
Tighten the hose clamps to 75
inch-lbs (not ft-lbs!).
58.
Re-install the air filter assembly
box and air box front cover.
-END, SEcTION 2-
nYLOcK nUt
StAndARd WASHER
tHREAd SEALinG
WASHER
BAnKS HiGH RAM
O-RinG
StUd
Figure 20
Fig 21