Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 32)

32
96811 v.10.0
Not needed if Banks PowerPDA will be
installed. Please proceed to Section 7.
Caution: Do not use excessive
force when working on plastic
parts. Permanent damage to the
part might result
For 2003-04 model year vehicles,
follow the selector switch
installation procedure Step 1.
For 2005-07 model year vehicles,
skip to Step 7.
1.
Remove the lower driver side
interior panel that allows access to
the fuse box.
2.
Remove the stereo using Ford
stereo removal tools as shown in
Figure 45. These are readily available
at automotive supply stores.
3.
Remove two (2) bolts that
reside above the stereo. These are
accessible once the stereo has been
removed.
4.
Detach the dash. At this point
the dash is held in place entirely by
removable fasteners. Disconnect all
electrical connections on the back of
the dash once it has been detached.
5.
Remove the dash from the
vehicle.
6.
cut out the Template 3 in Page
41 of this manual and tape to the
backside of the dash panel as shown
in Figure 46 for 2003-04 model year.
The template will be used as a guide
for drilling the holes to locate the Six-
Gun selector switch.
For 2003-04 model year vehicles,
skip to Step 9 to finish the selector
switch installation procedure.
7.
2005-07 Automatic
Transmission vehicles: Set the
vehicle’s parking brake. Insert the
key and turn the vehicle on without
starting it. Pull the shift lever down
into first gear to allow clearance for
dash panel removal.
All 2005-07 vehicles: Pull the plastic
trim surrounding the instrument
panel and radio / climate controls
towards you until it releases from
the main dashboard — it is attached
by a series of spring clips around its
perimeter. Disconnect all electrical
connectors from the back of the dash
trim and remove it from the vehicle.
8.
cut out the Template 4 in Page
39 of this manual and tape it to the
front of the dash panel as show in
Figure 47. The template will be used
as a guide for drilling holes to locate
Figure 45 Removal of the stereo (2003-04 model year vehicles only)
Section 6
INSTALLATION OF THE POWER LEVEL SELECTOR SWITCH
Figure 46: Template taped to back of dash on 2003-04 model year vehicle, ready
to be drilled.
2003-04 model year vehicles only
Figure 47 Template taped to front of dash on 2005-07 model year vehicle,
ready to be drilled.
2005-07 model year vehicles only