Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '08-10 Compatible with PowerPDA - Manual (Page 16)

16
96827 v.6.0
Figure 11 oBDII Connector
Installing Banks Brake Wire Harness
10.
connect the Banks Brake Wire
Harness OBD II connector to the
vehicle’s OBD II connector. Use a cable
tie, as shown in Figure 11 to secure
the Banks Brake Wire Harness to the
vehicle’s OBD II connector.
11.
connect the 8-pin connector from
the Banks Brake Wire Harness to the
8-pin connector on the Six-Gun In-Cab
cable.
12.
Locate the Foot Brake position
switch connector under the dash. See
Figure 12. Disconnect the foot brake
position switch connector.
13.
Locate the Brake Position
Switch intercept connectors on the
Banks Brake Wire Harness. connect
the female connector on the Brake
Position Switch intercept connectors
to the factory black brake position
switch connector. connect the male
connector on the Brake Position Switch
intercept connectors to the factory
female brake position connector that
was disconnected.
14.
From under the steering column,
loosen the screws that hold the
steering column panel covers in place.
15.
Move the steering column down
to the lowest possible position to aid
in removal of the top steering column
panel. Remove the top steering column
panel. See Figure 13.
CAUTION: Be careful when
removing the top steering column
panel or damage may result.
16.
Locate the tow haul connector
towards the top rear of the steering
column. See Figure 14.
17.
Disconnect the tow haul
connector.