Rough Country 276P - Manual (Page 5)

17. Using a 13mm socket and wrench remove the sway bar link. Save the stock hardware.
18. Remove the bolts holding the lower control arm, using a 24mm socket and wrench. Remove the arm and save the
stock hardware. See Photo 11.
19. Using an 18mm wrench remove the nut holding the outer tie rods to the steering link. Lightly hit the end of the center
link to dislodge the tie rod. If this does not work you may have to use a puller tool. Save the stock hardware. See
Photo 12.
20. Using a 21mm socket remove the stock bolt holding the steering link to the pitman arm. Retain stock nut for later
use. See Photo 13.
21. Remove the 4 bolts holding the front drive shaft to the differential using a 11mm wrench, retain the stock hardware
for later use. See Photo 14.
22. Remove the vent hose from the differential. Retain for later use.
23. Unplug the wires from the differential solenoid.
24. Using a 21mm wrench and socket remove the 2 bolts that hold the differential to the lower control arm frame mount.
Retain stock hardware. See Photo 15.
25. Place a jack underneath the differential. Using a 21mm socket remove the bottom differential nuts, retain stock hard-
ware. See Photo 16.
Photo 11 Photo 12
Photo 13 Photo 14
Photo 15 Photo 16