Rough Country 1272BOX4 - Manual (Page 12)

Thank you for choosing Rough Country for all of your suspension needs.
POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure for adequate clearance between all rotating, mobile, fixed,
and heated members. Verify clearance between exhaust and brake lines, fuel lines, fuel tank, floor boards and wiring
harness. Check steering gear for clearance. Test and inspect brake system.
2. On some vehicles the front lower skirting will need to be trimmed if using certain wheel /tire combinations and with
heavy offset wheels. Trim only as needed.
3. Activate four wheel drive system and check front hubs for engagement.
4. Have a qualified alignment center align the vehicle immediately. Realign to factory specifications. Have headlights
adjusted to proper settings.
6. Perform head light check and adjustment to proper settings.
7. Check and retighten wheels at 50 miles and again at 500 miles.
8. Recheck lifted height and adjust torsion bar as necessary.
9. All kit components must be retightened at 500 miles and then every three thousand miles after installation. Periodi-
cally check all hardware for tightness.
10. Install “Warning to Driver” decal on sun visor.
Note: Installation of larger tires will require speedometer recalibration.
OPTIONAL EQUIPMENT
Rough Country offers two optional items for this vehicle when lifted with our suspension system. Both of these
items are highly recommended, but not required. Part # 87320 is a single steering stabilizer kit and will help
with 35” tires to reduce front end wonder and steering integrity. Also available is a set of kicker braces that add
stability to frame for off road performance. Please contact your Rough Country distributor to order.
Optional Equipment:
Part # 1272 Box4-Kicker Braces