Rough Country 262.22 User Manual
Page 11
13. Install the supplied Rough Country 2.2 Series Performance
Shock Absorbers in the factory location with factory hardware.
Tighten using a 21mm wrench. See Photo 6. Note that these
shocks are designed to run piston down as shown.
14. Reconnect the ABS lines to the plastic retaining clip at the
bottom of each frame rail. The connector will not be reattached
to the top of the frame. Reroute the lines as needed to gain
proper slack.
15. Re-install tires and wheels.
16. Remove jack stands and lower vehicle to ground.
17. Place shock decals on shock absorbers and window decal on
vehicle.
TEMPLATE FOR SWAY BAR RELOCATION
Cut out template and position template on lower control arm as shown in Step 45.. Drill with a 11/16 drill bit and relocate the
sway bar end links into the new location.
Photo 6
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)