Rough Country 650 - Manual (Page 3)

Rear Installation Instructions
1. Jack up the rear of the vehicle and support the vehicle with jack stands, so that the rear wheels are off the
ground. Chock front wheels.
2. Remove the rear tires/wheels , using a 19mm deep well socket.
3. Using a 17mm wrench and 17mm socket, remove the lower sway bar bolt. Retain hardware for later use.
See Photo 5.
4. Remove the factory shock absorbers.
5. Push down on the axle to allow enough room for stock coil spring to be removed. Remove the stock coil
spring.
6. Remove the factory bump stop from the metal bump stop cup.
7. Using a 15mm socket unbolt the bump stop cup.
8. Install the coil spring spacer over the bump stop pocket and up into the mount, with the lip of the spacer
pointing down.
9. Install the supplied bump stop spacer with the supplied 10mm 80mm bolt.
10. Using the 15mm socket re-install the bump stop cup onto the bump stop mount with the supplied spacer in
between the mount and the bump stop cup with the supplied 10mm x 80mm bolt and washer.
11. Reinstall factory bump stop into cup.
12. Reinstall the factory coil spring. See Photo 6.
13. Using the17mm-wrench and 17mm socket, replace the lower sway bar bolt.
14. Install the rear shocks at this time.
15. Reinstall the rear tires/wheels.
16. Lower the vehicle to the ground.
Photo 5 Photo 6