Rough Country 481.20 - Manual (Page 6)

POST INSTALLTION INSTRUCTIONS
1. Perform steering sweep. The distance between the tire sidewall and the brake hose must be checked closely. Cycle
the steering from full turn to full turn to check for clearance. Failure to perform inspections may result in component
failure.
2. Have a qualified alignment center realign front end to factory specs.
3. Install Warning to Driver decal on sun visor.
4. Re-torque all nuts, bolts, and especially u-bolts after the first 100 miles, again after another 100 miles and then
check periodically thereafter.
5. All components must be retightened after 500 miles, and every three thousand miles after installation
6. Adjust headlights to proper settings.
7. Locate shock part number 658049 Hydro Shock / 658048-
Nitro shock and assemble poly bushings and sleeve in
shock.
8. Using a 18mm socket and wrench on the bottom and
10mm socket on the upper, install using factory hardware
on upper and lower shock mount.
9. Install the tires and wheels.
10. Reinstall the e-brake cable mount to the spring plate with
the stock hardware using a 10mm wrench. See Photo 6.
11. Jack up the rear of the vehicle and remove the jack
stands. Lower the vehicle to the floor.
Photo 6
KIT CONTENT
REAR BLOCKS AND
U-BOLTS
TRACK BAR
BRACKET
FR LEAF SPRINGS
PITMAN ARM
SWAY BAR BRKTS