Rough Country 75105-15 - Manual (Page 6)

PowerBoard ® – Installation Instructions
Rev. R 0713 75105 pg. 6
Connect Wires
Posi-Tap™
Trigger
Wire
Locate the appropriate signal wires as shown
in the table.
Use the Posi-Taps™ to splice the trigger wires
into the corresponding door ajar wires. The
SuperCrew is the only application with four
doors so it is the only one that will use all four
(4) wires. Tape off the unused trigger wires on
the SuperCab and Regular Cab.
Posi-Tap™ Instructions
Insert Tighten
Strip 3/8" Insert and
Tighten
There will be three (3) Black wires
with Blue Stripes. Use the one that
looks unique (ie. has a different blue stripe
either weight or shade).
SUPERCREW SUPERCAB REGULAR CAB
Black / Yellow Black / Yellow Black / Yellow
Black / Pink Black / Pink Black / Pink
Black / Blue
Black / White
Clean the outboard surface
of the of the Linkage below
the bottom mounting bolt.
Peal the adhesive liner off
the back of the Light and
fi rmly press it 1/8" below
the mounting bolt. Plug the
light into the connector with
the black and orange wires
in the wire harness. Repeat
with the other three lights.
Secure lose wires with
Cable Ties.
Install Lights
Light
Linkage
Install Running Boards
M6-1.0 x 20mm
Socket Head Bolts Linkage
PowerBoard ®
M6-1.0 x 20mm
Socket Head Bolts
M6-1.0 x 20mm
Socket Head Bolts
Mount the Steps to the linkages. Slide the mounting
T-Nut into position. Install M6-1.0 x 20mm Socket Head
Bolts to secure the boards. Use a 5mm Allen Wrench to
tighten the bolts.
Make sure the board moves up and down freely by hand.
If it binds, loosen the linkage to body attachment bolts
and adjust the linkage position until the boards move
freely. Do not tighten the bolts at this time.
Tightening the fasteners
before cycling the step
several times may create a bind,
causing a squeaking sound
and preventing the boards from
retracting completely and evenly.