Rough Country 75105-15 - Manual (Page 5)

PowerBoard ® – Installation Instructions
Rev. R 0713 75105 pg. 5
Connect the red power lead to the positive battery terminal and the black lead
to the negative terminal. Route the longer leg of the harness across the front
of the engine compartment and down to driver’s side wheel well. Route the
shorter leg to the wheel well on the passenger’s side. Use the wire ties in the
parts kit to secure the harness out of the way.
Reinstall the Fan Shroud.
Wiring Harness
Wire
Tie
To Driver’s Side Wheel Well
To Passenger’s
Side Wheel Well
Attach Wiring Harness to Battery
Puncture the grommet in the fi rewall and thread the four Trigger Wires from
the Wiring Harness through the fi rewall.
Wiring Harness
Puncture
Grommet Trigger Wires - Thread
through grommet
Wire Harness Cover
Front Arm
Install Trigger Wires
Remove the Step Plates from the front and rear door openings
on the driver’s side. Roll back the carpet to access the wiring
underneath.
Pull the wires from the grommet along the door opening next to
the wire harness to the rear door opening.
Remove Step Plate
Wiring
Harness
Front Door Opening
Wiring
Harness
Rear Door Opening
Remove Driver’s Side Front and Rear Step Plates