Rough Country 56822-35 - Manual (Page 4)

Rev. G 0113 56822 pg. 4
Trektop NX Installation Instructions
Mount Header Assembly to
Quick Release Brackets
Fold the Top Fabric toward the front of the Header.
Pull back on the Quick Release Knob on the Side
Bow and secure to the Quick Release Bracket on
both sides of the vehicle.
Once the Header Assembly is secure, tighten the
screws that secure the Quick Release Brackets.
Install Rear Bow
Rear Bow
Drape the Top Fabric over the Top Arch and
sport bar.
Drape Top Fabric over Vehicle
Open the Header back toward the rear. Run the
cable under the Door Surround screw and through
the Cable Bracket. Hook the cable spring to the
outer hole on the bracket.
Secure Cable Spring
To increase spring tension for a tighter
fi t, hook the spring into one of the inner
holes in the Cable Bracket.
Quick Release
Bracket Quick Release
Knob
Door
Surround
Cable
Spring
Cable Under
Screw
Peel the backing off the Driver’s Side Foam Seal
and install it on the driver’s side of the Header.
Repeat on the passenger side.
Install Foam Seal
Header
Foam Seal
Driver’s Side Shown
Slide the Rear Bow into the pocket inside the rear of
the Top Fabric. Secure the J-Hooks on the rear bow
fl aps to the ends of the Rear Bow.
Hook J-Hook
to Rear Bow