Rough Country RC609 - Manual (Page 5)

24. Reinstall the shroud on the bracket with the supplied 1/4”
lock nuts and flat washers. See Photo 13.
25. Reinstall the coolant reservoir and power steering reservoir
to the fan shroud if applicable. Use a 13mm for stock bolts
and 7/16” for new nuts.
26. Reconnect the air intake to the air filter housing and throttle
body.
27. Reinstall plastic jeep cover and metal plate using 3/8”
socket. Metal plate should go under the body mount. Install
hard brake line back into clips.
28. (AUTO TRANSMISSION ONLY) Proceed to installation
instructions for automatic shifter bracket.
29. Re-Check all fastener to confirm all components are not
binding or in the way of moving parts.
Photo 13
REINSTALL THE SHROUD TO THE BRACKETS
AUTOMATIC SHIFTER BRACKET INSTALLATION
(FOR VEHICLE EQUIPPED WITH AUTOMATIC TRANSMISSION ONLY)
1. Using the supplied shifter location bracket, mount to the
stock shift linkage bracket with the supplied 1/4” hard-
ware and tighten. Note: The bolts will point toward the
engine.
2. Mount the assembly in the stock location on the engine
bracket and secure with stock cotter pin.
3. Mount the assembly in place on the original frame location
with the stock hardware and tighten. See Photo 1.
Photo 1
POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering gear for interference and proper working order. Test brakes.
2. Check to ensure metal brake lines have sufficient slack to eliminate interference and maintain proper working order.
Failure to perform inspections may result in component failure. Readjust headlights to proper settings
.
MAINTENANCE INFORMATION
It is the buyers ultimate responsibility to have all bolts/nuts checked for tightness after the first 100 miles and then
every 1000 miles. A qualified professional mechanic must inspect wheel alignment steering system, suspension and
driveline systems at least every 3000 miles.