Rough Country 1062 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
1. Place vehicle on a flat surface and set emergency brake.
2. Using a small phillips screwdriver, remove the 2 plastic screws on top of the front bumper cover. See Photo 1.
3. Remove the 4 plastic screws holding the skid plate to the front bumper, using a small Phillips screw driver. See
Photo 2.
4. Using a 18mm socket, remove the 4 bolts holding the bumper to the frame horn on the driver and passenger side.
See Photo 3.
5. Find the plug for the fog lights if equipped and unplug. See Photo 4.
6. Remove Bumper.
7. Remove the stock tow hook brackets if equipped.
8. Installation of the roller fairlead / hawse lead and winch on the winch plate is performed next in order to ease installa-
tion.
9. Install the roller fairlead / hawse lead with the appropriate hardware that was included with the winch and tighten.
See Photo 5.
10. Install the cable through the fairlead and install hook.
11. Install the winch on the winch plate with the hardware that was included with the winch and tighten. Bottom of winch
plate pictured. See Photo 6.
Photo 1 Photo 2
Photo 3 Photo 4
REMOVE BUMPER COVER HARDWARE REMOVE BUMPER COVER HARDWARE
REMOVE BUMPER HARDWARE REMOVE BUMPER COVER HARDWARE REMOVE BUMPER COVER HARDWARE
INSTALL ROLLER FAIRLEAD INSTALL WINCH ON PLATE
Photo 5 Photo 6