Rough Country 900.20 - Manual (Page 5)

16. Install the bushings and 12mm sleeves on the top and bottom of the sway bar link at this time. Install the upper part
of the new link in the hoop bracket with the 12mm bolts and flange lock nuts. The bolt will be installed with the
threads out and head toward the frame. Install the lower link in the stock mount with the 12mm bolts, washers and
nuts. Hardware is in 1687Bag1. Tighten using a 18mm and 19mm wrench. See PHOTO 11.
17. Install the track bar in the axle mount location as shown in PHOTO 12. Install the stock bolt in the upper hole and
tighten. Assemble the front shock absorbers, part # 651896 hydro / 651997 Nitro and install using the factory hard-
ware on the bottom of the shock. Torque to 20 ft/lbs, Install the upper stud bushings and tighten the upper mounting
point until bushing swells slightly Repeat for opposite side.
18. Install the tires/wheels and lug nuts, using a 13/16” deep wheel socket. Lower the vehicle to the ground.
19. Tighten the lower control arms, using a 21mm socket and 21mm /18mm wrench.
20. Tighten the upper control arms using a 15mm & T-50 bit.
PHOTO 12
REINSTALL THE TRACK ROD
PHOTO 11
INSTALL THE LINK ON THE AXLE