Rough Country RC604 - Manual (Page 5)

SHIFTER INSTALLATION INSTRUCTIONS FOR MANUAL SHIFT JK
1. Pull the shift knob from the shifter rod. See Photo 1.
2. Remove the shifter boot bezel from the center console. See Photo 2. Note: There are two clips in the rear that
must be released first then the bezel can be removed.
3. Remove the inner boot. See Photo 3.
4. Using a T-45 torque head bit, remove the shifter from the transmission stub shaft. See Photo 4. Retain the
hardware for reuse.
5. Install the shifter adapter, making sure the adapter is fully pressed down on the transmission stub.
6. Make sure the shift adapter is straight. Apply the thread locking compound and install the 8mm allen head bolt.
Tighten using a 6mm allen wrench. See Photo 5.
7. Apply thread locking compound and install the supplied 1/4” set screw in the shifter adapter. Tighten the set screw
using a 1/8” allen wrench. See Photo 6.
PHOTO 1 PHOTO 2
REMOVE SHIFTER KNOB REMOVE SHIFTER BOOT BEZEL
PHOTO 3 PHOTO 4
REMOVE INNER BOOT REMOVE THE SHIFTER
PHOTO 5 PHOTO 6
INSTALL SHIFTER ADAPTER TIGHTEN THE ALLEN BOLT