Rough Country RC604 - Manual (Page 2)

INSTALLATION INSTRUCTIONS FOR JEEP JK 2 AND 4 DOOR BODY LIFT
1. Place Jeep on clean, dry, level surface. Installation is done one side at a time.
2. Raise hood. Using a Phillips screw driver, remove the (6) push pin inserts from grill on top side as shown. Retain for
re-use. See Photo 1.
3. Pull grill toward you to release the three lower clips. See Photo 2.
4. Disconnect the parking light electrical connecter and remove grill assembly. See Photo 3.
5. Using a 16mm wrench remove the 2 stud nuts from the stock body mounts as shown (12 mounts for 4 door and 8
mounts for 2 door), removing only the passenger side first. See Photo 4.
6. After completion of removing the stud nuts, remove the center stud bolt and washer from the passenger side body
mounts using a 18mm wrench . See Photo 5
7. After all isolator nuts and center mounting bolts are removed from the passenger side, position a wood block and (2)
jack stands under the body as shown. Lift the body upwards and begin removing the body mounts. See Photo 6.
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 6 PHOTO 5