Rough Country RC604 User Manual
Page 4
1. Remove the stock bumper brackets from the frame rail and the bumper as shown in Photo 1 & 2 using a 16mm
socket.
2. Remove the inner brackets from the frame rail as shown in Photo 3 from the driver and passenger side. Retain the
hardware for reuse.
3. Remove the stock bumper from the vehicle.
4. Install the inner bumper brackets on the bumper as shown in Photo 4 using stock hardware. Do not tighten at this
time.
5. Install the bumper on the frame and install the outer bumper brackets with the stock hardware. Do not tighten at this
time. See Photo 5.
6. Align the bumper and tighten all hardware with a 16mm socket. See Photo 6.
REAR BUMPER BRACKET INSTALLATION INSTRUCTIONS
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
See also other documents in the category Rough Country For the car:
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)