Rough Country RC611 - Manual (Page 4)

10. Move parking brake cable over exhaust hanger to allow the body to jacked up. See Photo 7.
11. Using a 3/4 wrench to loosen the lock nut securing the manual shifter shift knob on shifter and 4x4 lever. Remove
both knobs. See Photo 8.
12. Remove shifter boot bolts using 8mm socket. See Photo 9.
13. Then remove screws holding in shifter bezel. See Photo 10. Pull bezel up past carpet.
14. Loosen but do not remove the 11 body bolts. One is under center of grill, three are under doors, two above rear axle
and two at each rear corner using a 5/8 socket. See Diagram 1 on Page 2.
15. Only remove bolts from one side at a time. Front center bolt must be remove for both sides. Using floor jack or jack
stand and a wood block slowly raise body from frame only enough to install body puck. Watch for wires, brake
lines and cables. Make sure nothing is binding. It may be necessary to unclip brake lines to allow for travel.
16. The 3” x 3” body puck go on the three body mounts under doors. See Diagram 1 on Page 2. Install the 3 supplied
1/2” x 6 1/2” bolts. See Photo 11. Do not tighten at this time.
17. The smaller 3” x 2” body puck will go in the other 5 body mounts as shown in Diagram 1 on Page 2. See Photo 12.
Install the supplied 7/16” x 5-1/2” bolts. Do not tighten at this time.
Photo 7
Reposition the E-brake cable over muffler mount
Photo 9
Remove outer boot
Photo 10
Remove inner boot
Photo 11
Install spacers Location 1( See Diagram 1)
Photo 12
Install spacers Location 2( See Diagram 1)
Photo 8
Remove shifter knobs