Rough Country 746.20 - Manual (Page 9)

55. Repeat steps 39-54 on the driver side of the truck.
56. Align the front skid plate with the two passenger side bolt holes on the bottom of the front cross-member and insert
two of the 3/8” x 1.25” bolts and washers from 1746bag2. Hand tighten. See Photo 29. Use the factory hardware on
the top of the skid plate and tighten with a 17mm socket.
57. Using four of the 3/8” x 1.25” bolts and washers from 1746bag2, bolt the lower skid plate to the driver side of the
front and rear cross-member. Tighten all upper and lower cross-member bolts using 9/16” socket. See Photo 30.
58. Install tires and wheels and set the truck on the ground. Using a 19mm wrench tighten the lower control arm cam
bolts.
PHOTO 29 PHOTO 30