Rough Country 746.20 - Manual (Page 5)

16. Place a jack or jack stand below the lower control arm and remove the top three strut nuts with a 14mm wrench.
17. Using a 19mm socket and wrench remove the bolt on the lower strut mount. See Photo 6. Remove the strut from
the truck and set aside.
18. Next remove the sway bar from the frame using a 14mm socket. See Photo 7.
19. Remove the lower control arm with a 19mm socket and wrench. See Photo 8.
20. Repeat steps 4-19 on the driver side.
21. Remove the front driveshaft from the diff using a 14mm socket. Retain factory hardware. See Photo 9.
22. Unplug the vent tube and remove the diff actuator using a 12mm socket. Remove the actuator wires from the diff on
the passenger side. Unplug and remove the vent tube from the top of the diff using a 12mm socket.
23. Support the diff with a jack, remove the driver and passenger diff bracket using a 22mm socket on the frame side
and a 19mm socket on the diff side of the bracket. See Photo 10.
24. Using a 12mm Allen socket remove the rear diff mount. See Photo 11.
25. Lower the diff on the jack and remove from the truck.
PHOTO 11 PHOTO 10
PHOTO 6 PHOTO 7
PHOTO 9 PHOTO 8