Rough Country 746.20 - Manual (Page 8)

46. Install factory axle nut and tighten with a 35mm socket. Push in the factory cotter pin to secure nut. See Photo 23.
47. Using a 12mm wrench install the new brake line bracket to the frame using stock hardware. Use the supplied 5/16”
bolts, washers, and nuts from 1746bag5 to bolt the factory bracket to the new drop bracket. Tighten with a 13mm
socket and wrench. See Photo 24.
48. Push on the dust cap over the axle nut and slide on the brake rotor. Using factory hardware and a 17mm wrench
install the brake caliper to the new knuckle.
49. Using a 5mm Allen wrench install the ABS sensor to the new knuckle with factory hardware.
50. Reinstall the ABS bracket to the knuckle using factory hardware and a 12mm socket.
51. Install the brake line bracket to the new knuckle using a 12mm socket. See Photo 25.
52. Install the sway bar to the new relocation bracket with the supplied 3/8’ bolts from 1770bag4. Tighten with a 9/16
socket. See Photo 26.
53. Insert the sway bar link through the new knuckle and secure using factory hardware. Tighten with a 14mm socket.
See Photo 27.
54. Insert the tie rod end into the knuckle using factory hardware. Tighten with a 19mm wrench. Reinstall the factory cot-
ter pin. See Photo 28.
PHOTO 26 PHOTO 25
PHOTO 24 PHOTO 23
PHOTO 27 PHOTO 28